Skip to main content

ll-Shape Templates

Naming​

Group nameType
Linear_1Mandatory
Linear_2Mandatory
IslandOptional

Circulations​

We have added circulations only for the island as follows:

  • Front=600mm
  • Right=600mm
  • Back=600mm
  • Left=600mm

Note:
When chairs are on the island, we put circulation of 300mm on the chair side.

Constraints​

Relative Placement: Face to Face​

This constraint will allow the two reference wall of each group (Linear_1 and Linear_2) to be face to face.

Alignment Between the Linears​

For design consistency we will add an alignment between Linear_1 and Linear_2 so that they appear aligned within a 500mm range. Margin of error = 500mm.

Distance​

For design consistency, we apply a distance constraint between Linear_1 and Linear_2 so that they are not too close or too far from each other in the consumer room.

  • Min value = 1200mm
  • Max value = 3500mm

Same Wall​

Apply the same wall constraint between Linear_1 and Island so that when offering solutions the island will always be on the same side. Otherwise, the user could end up with four solutions and only the island turning around.

Alignment Between an Island and the Linear​

Alignment constraint ensure to have the island not far away from the Linear_1. We suggest a default value of 1000mm meaning that the island could go on the left or right side of the selected axis until 1000mm. The reason behind such a big number is that we would rather have an island not perfectly aligned but present than not-so that the sales associate will have a discussion about the island with the consumer. When aligning, try to respect as much as you can the original template.
Applied between two linear groups Linear_1 and Island with default value = 1000mm.